HARLEY DAVIDSON FOUR-POINT DETACHABLE DOCKING HARDWARE KIT INSTALLATION MANUAL
download INSTALLATION 1. See Figure 3. Remove the screw (A) retaining the rear of the chrome cover to the rear frame extension on each side of the vehicle. 2. Place a washer (7) over the threads of...
View ArticleHARLEY DAVIDSON CHROME REAR WHEEL KIT INSTALLATION MANUAL
download Kits 41017-00, 41026-00 and 41262-03 are designed for installation on 2000 and later XL, FXD and 2000-2002 Softail Model Motorcycles (except FXSTD and FLSTS). Kits 41260-03, 41261-03 and...
View ArticleHARLEY DAVIDSON FENDER SUPPORT COVER KIT REMOVAL AND INSTALLATION MANUAL
download REMOVAL NOTE Complete all removal and installation procedures on one side before performing on the other side. 1. See Figure 1. Remove rear turn signal assembly (2) following the instructions...
View ArticleHARLEY DAVIDSON SOFTAIL EXTENDED REACH CONTROLS KITS INSTALLATION MANUAL
download PREPARE THE MOTORCYCLE 1. For models equipped with saddlebags: Remove the saddlebags following the instructions in the appropriate Service Manual. 2. Remove the seat following the directions...
View Article1984-1999 HARLEY DAVIDSON Softails ULTIMA NARROW BODY ADJUSTABLE SOFTAIL...
download Adjusting ride height Step 1. Loosen ride height adjusting locknut (see fig 1) Step 2. Loosen eyelet end to desired length/height (see fig 2) Step 3. IMPORTANT: Always verify that there are...
View ArticleHARLEY DAVIDSON CHROME 1.25 INCH (31.75 MM) DIAMETER HANDLEBAR KIT...
download CHROME 1.25 INCH (31.75 MM) DIAMETER HANDLEBAR KIT GENERAL Kit Number 56032-08 Models For model fitment information, see the P&A retail catalog or the Parts and Accessories section of...
View ArticleHARLEY DAVIDSON TIMKEN BEARING CONVERSION TOOL INSTALLATION MANUAL
download 2-ton press (must be square to within .010″, ram to table) Inch-lb torque wrench Foot-lb torque wrench T15 TORX® drive socket (for inch-lb torque wrench) 5/32 inch hex drive socket (for...
View ArticleHARLEY DAVIDSON DYNA STATOR AND ROTOR KIT INSTALLATION MANUAL
download REMOVAL To prevent accidental vehicle start-up, which could cause death or serious injury, disconnect negative (-) battery cable before proceeding. (00048a) 1. Disconnect negative battery...
View ArticleHARLEY DAVIDSON SADDLEBAG HINGE STOP KIT INSTALLATION MANUAL
download INSTALLATION 1. See Figure 2 and Table 1. Remove the saddlebag by opening the lid and turning the two bail head studs (1) 1/4 turn. Save the washers (A) and discard one of the studs (1). The...
View ArticleHARLEY DAVIDSON FRONT FORK STEM BOLT CHROME COVER KIT INSTALLATION MANUAL
download INSTALLATION 1. See Figure 1. Remove stock front fork stem bolt and washer (if equipped). 2. Install front fork stem bolt (2) and washer (3) from this kit. Properly adjust fork stem bearings....
View Article
More Pages to Explore .....